Filter
Top Products
INSTALLATION
Step 1 – Set the option switches
Set the option select “DIP” switches to match your requirements for play mode,
bandwidth, and speaker on/off.
“off”
“on”
Figure 3 - Option Select Switches
This example is for illustrative purposes only.
Your actual switch settings will vary.
A switch is “ON” when it is pointing TOWARDS
the switch numbers. The switch is
“OFF” when it is pointed AWAY FROM the switch numbers. In the picture shown
above, switch 1 is “off” and switch 2 is “on.”
Switch # Option Possible Values
1 Message play
On = Trigger play enable
Off = Continuous play (MOH)
2-3 Bandwidth
2 Off, 3 Off = 3.5KHz/34KBps
2 On, 3 Off = 7.0KHz/69KBps
2 Off, 3 On = 7.0E KHz/92KBps
4 Factory Test
Not Used
Table 3 - Option Select Switches
IMPORTANT NOTE
: Changes to the bandwidth setting do not take effect
until power is recycled and the tape reloaded.
Continuous or Trigger Play, Switch 1
For most applications, including message on hold, message play should be set
to continuous (switch off). If the switch is on, the message will play
continuously until the external trigger is plugged in. Momentarily activating the
trigger will play the message once.
SoundBrick 500 01/08/2001
9