Filter
Top Products
17
Performing a Self Test
The Self Test option, which appears on this screen, verifies the operation of
the 2402 telephone’s lamps and display components. While the telephone is
running in self-test mode, you cannot make and receive calls using the
dialpad and call-handling buttons.
To have the 2402 telephone perform a self test
1. While on-hook, press and hold .
The lamps go on steadily, and all the display segments fill in.
2. To end the test, release .
Using Selected Voice Features
The following features are available only if your system manager has
administered them as feature buttons on your 2402 telephone or has supplied
you with the required feature access codes.
How to Access a Voice Feature
When you want to use one of the voice features on the 2402 telephone, you
can access the feature in one of two ways:
• You can access up to 12 features by pressing and then the dial pad
key (1 through 9, 0, *, or #) that corresponds to that feature. These features
are administered on your telephone by your system manager. (The red
lamp next to
goes on steadily when the button is pressed to let you
know that your dial pad is now in the Feature selection mode.)
For example, if the Send All Calls feature is assigned to dial pad key 1, you
can press , and then dial 1 to use this feature.
Note: As your system manager assigns features to the Feature Directory
slots (1 through 9, 0, *, and #), be sure to write the feature in the
Feature Directory table (below). This directory list provides a
convenient quick reference for the 12 features programmed on the dial
pad.
Self Test