Filter
Top Products
9
NOTE: To communicate with other units, they must be switched to the same
channel and CTCSS subcode. To communicate with other units that
do not have subcodes, switch your unit to the same channel with the
subcode set to Off.
AUTO CHANNEL SCAN MODE:
This feature allows scanning for an active channel. The volume cannot be adjusted
and the power saver is disabled in this mode. To access the Auto Channel Scan
menu:
1. Press the Function Button (I 2) until the auto channel icon blinks and SC appears
in the LCD Panel (8).
2. Press the Up Button (10) or the Down Button (11) to choose scanning up or
down from the current channel number.
3. Press the Enter Button (I 3) to confirm your selection.
The unit will begin scanning for an active main channel. If a transmission is
detected, the Receive and RSSI icons will appear in the LCD Panel (8). To turn off
the auto channel scan feature in the standby mode, simply press the Function
Button (12) once. You can pause on any channel while in the Auto Channel Scan
Mode by pressing the PTT Button (4) during the reception of a signal for 5 seconds
afterward. Pressing the Monitor Button (2) will resume scanning and eliminate that
channel from those being scanned.
DUAL WATCH SCAN MODE
This feature allows the monitoring of two different channels at the same time. If any
priority channel other than the current channel in use is preset, the preset channel
will be scanned every 0.5 second and you will signaled when a call is received.
While in the Dual Watch Scan Mode you may hear transmissions from either a
primary or secondary channel when transmitting. The unit will always transmit on
the primary channel unless the PTT Button (4) is pressed during or immediately
following the reception of secondary channel transmission. The power saver mode
is disabled in the Dual Watch Scan Mode and the volume is not adjustable. To
access the Dual Watch Scan menu:
1. Press the Function Button (12) until the dual watch icon blinks and d
appears in
the LCD Panel (8).
2. Press the Up Button (10) or the Down Button (II) to select the desired channel
number you wish to monitor.
3. Press the Enter Button (13) to confirm your selection.