Filter
Top Products
4
CH Channel select mode (1-14)
ctc Coded Tone Controlled Squelch System Sub-Channel Select Mode
SC Auto Channel Scan Mode
d
Dual Channel Watch Mode
UO Voice Activated Function
Udt Voice Activated Recovery Time
ALO Auto Key Lock Selection Mode
CAL Call Ringer Melody Selection Mode
ton Sub-Channel Number or Sub-Channel Frequency
15. Small Segment Display: Displays the CTCSS tone option in the normal mode.
The CTCSS option is shown in Hz.
When the Function Button is pressed, the FR1438-2 selection of each menu is
displayed in the following sequence and format.
(1 through 14) (CH) Channel Number
(1 through 38 or Frequency, OFF) (cTc) Sub-Channel Frequency in Hertz or
Number
(Up, Down, OFF) (SC) Auto Channel Scan Mode
(Channel Number 1 through 14, OFF) (d
) Dual Channel Watch Mode
(High,Off, Low) (UO) Voice Activated Function
(Choice of 5,3,2,1 seconds) (Udt) Voice Recovery Activated Time
(Off, Auto) (ALO) Auto Key Lock Selection Mode
(1 Through 7) (CAL) Call Ringer Melody Selection
(Number) or (Hertz) (ton) Sub-Channel Frequency (Number = no,
Frequency = Freq)
Powering the transceiver:
Your FR1438-2 radio transceiver operates on four AAA batteries . You may operate
your FR1438-2 using the rechargeable batteries included or you may use alkaline
batteries. Alkaline batteries will provide slightly better performance than the
rechargeable batteries, but must never be recharged in the charging stand.
Installing the batteries:
To install batteries into the radio, it is necessary to remove the belt clip. To do this you
will need to release the spring clip securing the belt clip to radio and lift the belt clip
away from the radio body. Next, remove the battery compartment cover by sliding it
downward towards the bottom of the transceiver. Observe the polarity symbols on
the bottom of the tray when inserting the batteries. Replace the cover.