Filter
Top Products
17
Getting started
Headset base installation
Adjust the lifter audio
Press MODE on the headset base to
change the mode if the LIFTER MODE
light is not on. Make sure that the LIFTER
MODE light on the headset base is on.
Lift the corded handset from the
telephone cradle.
After you install and charge the battery
(see pages 8-10), put the headset next to
your ear.
Press ON/OFF on the headset to listen for
a dial tone.
If there is no dial tone or the dial tone is
not clear, slide the LIFTER AUDIO ADJUST
switch on the side of the headset base
from A to G until the dial tone is clear.
If the dial tone is not clear, repeat step 5
until you find the clearest dial tone.
1.
2.
3.
4.
5.
6.
ON/OFF
MODE
LIFTER MODE light
LIFTER AUDIO ADJUST