Filter
Top Products
11
Getting started
Headset base installation
No lifter mode or lifter mode
There are two answer modes available on the
headset base. The current mode is indicated
by the NO LIFTER MODE or LIFTER MODE lights
on the front of the headset base.
When plugging your headset base into the
telephone wall jack (installation option 1
or 2), make sure the headset base mode is set
to NO LIFTER MODE.
-OR-
When connecting your headset base to a multiple line corded
telephone (installation option 3), make sure the headset base mode
is set to LIFTER MODE and that the LIFTER AUDIO ADJUST is
switched for the best headset audio quality (see page 17).
To change the answer mode:
When the headset is not in use, press MODE on the headset
base to select NO LIFTER MODE or LIFTER MODE. The
corresponding light on the front of the headset base turns on to
indicate the current mode.
For complete instructions on installing and using the handset lifter,
see the TL7100 handset lifter user’s manual. You may also download
the manual at www.telephones.att.com/manuals.
NOTE: If you are using the handset lifter (TL7100 purchased separately), you
must use LIFTER MODE.
•
•
MODE