Filter
Top Products
Troubleshooting
Troubleshooting
20
The battery
does not hold
a charge.
• If the remote dial pad is in its charger and
the CHARGE light does not come on, refer
to The CHARGE light is off on page 22 in
this Troubleshooting section.
• Ensure that the battery is correctly installed
with the plug securely connected.
• Charge the battery in the remote dial pad
for at least six hours. For optimum daily
performance, return the remote dial pad to
its charger when not in use.
• You may need a new battery. Please refer to
• Follow the directions for dial pad
registration on pages 6-7. Wait for several
seconds until the screen message changes
to DIAL PAD, confirming that registration
was successful.
• Disconnect and re-install the remote dial
pad battery, then perform the dial pad
registration procedure again.
• Reset the headset base. Unplug the unit’s
electrical power. Wait for 15 seconds and
plug it back in. The remote dial pad needs
to be registered again.
• Other electronic products can cause
interference to your cordless phone. Try
installing your phone as far away from
these types of electronic devices as
possible: television sets, VCRs, or other
cordless telephones.