Filter
Top Products
PLEASE WAIT...
7
DIAL PAD
1
NOTES:
1. You cannot register a remote dial pad if a system headset is in use.
2. If the registration is not successful, the display shows
NOT REGISTERED. Reset
the remote dial pad by lifting it out of the charger and then placing it back in the
charger. Now try the registration process again.
3.
If you have one registered headset, the remote dial pad automatically connects to
the headset after registering on the headset base.
4. If you have two headsets, and you want the other headset to work with the
remote dial pad, you have to de-register all the headsets and the remote dial
pad first. Refer to the de-registration information on page 8. Then re-register the
headsets and dial pad.
5.
Registration time depends on environmental conditions and varies.
Register the remote dial pad to the headset
base (with two headsets)
• The dial pad can only be paired with one
headset, even if there are two headsets
in your system. The dial pad pairs with
the most recently registered headset. The
display indicates the paired dial pad by
showing either
1
or
2
.
DIAL PAD
2
DIAL PAD
1
(until the red MUTE light on the headset
base turns on) and then release the
button. The remote dial pad shows PLEASE
WAIT..., then DIAL PAD REGISTERED. It
takes about 30 seconds to complete the
registration.
4. The MUTE light turns off and you see
the DIAL PAD screen (shown on the left)
indicating successful registration.
DIAL PAD
1
REGISTERED
Getting started
Remote dial pad registration and de-registration