Filter
Top Products
5
TL7610/TL7611 headset base installation
1. Unplug the curly handset cord from the telephone and plug
it into the CURLY CORD jack (light blue dot) on the
headset base.
2. Plug one end of the telephone line cord (provided with the
headset base) into the base handset jack on the telephone
where the curly handset cord was plugged in.
3. Plug the other end of the line cord into the BASE JACK
(orange dot) on the headset base.
4. Plug the lifter control cable into the jack of the TL7610/
TL7611 base adapter.
5. Plug the other end of the TL7610/TL7611 base adapter into
the LIFTER jack (blue dot) on the headset base.
Adjust the corded handset audio (see page 6) before you install
the handset lifter to your telephone.
Handset lifter installation
Getting started
Telephone
wall jack
1
2
3
A DSL filter (not included)
is required if you have DSL
high-speed Internet service.
Telephone
line cord
Plug the small end of the
headset base power adapter
to the POWER jack (green dot)
on the headset base.
Plug the large end of the
headset base power adapter
into a power outlet not
controlled by a wall switch.
5
4