Filter
Top Products
36
Answering system
"Number of rings,"
current setting, then
"To change the setting
press SKIP or REPEAT;
to continue setup, press
SETUP."
Options: 2/4/6/toll saver
“Base ringer,” current
setting, then “To change
the setting, press SKIP
or REPEAT; to continue
setup, press SETUP.”
Options: high/low/off
"Remote access code,"
current setting, then
"To change the setting
press SKIP or REPEAT;
to continue setup, press
SETUP."
Options: (select a two-
digit code) 19
"Message alert tone,"
current setting, then
"To change the setting,
press SKIP or REPEAT;
to continue setup, press
SETUP."
Options: on/off
Choose number of rings before
the system answers a call. When
toll saver is active, the system
answers after two rings if you
have new messages, and after
four rings if you have no new
messages. If you are making a
long distance call to retrieve
messages, you may disconnect
your call after three rings so that
there will be no long distance
charge incurred.
Choose the base ringer volume
between high and low level, or
turn the base ringer off.
Select a two-digit number (10-99)
for remote access from another
telephone (page 41).
When on, the telephone beeps
every 10 seconds when there are
new messages.
NOTE: Press and hold
SKIP
or
REPEAT
to
increase or decrease the
remote access code number
by 10.
NOTES:
1. The message alert tone
will beep only if all the
conditions below are met:
Answering system is on;
Message alert tone
setting is on;
There are new messages.
2. Press any base key to
temporarily silence the
message alert tone. If you
press DELETE twice
while the phone is not
in use, you will delete all
old messages and the
message alert tone will be
temporarily silenced. The
message alert tone will be
re-activated with the next
incoming message.
Changing feature options
You can set and change the answering system
features described below:
1. Press SETUP repeatedly until you hear the
feature you want to modify.
2. Press SKIP or REPEAT to change the
setting.
3. Press SETUP to set your selection and move to
the next menu option.
4. Press PLAY/STOP to confirm the setting
and exit the menu.
Feature options (Default settings underlined)
System announces: Feature description:
RECORD
ANNC.