Filter
Top Products
8
Getting started
8
Battery installation & charging
After battery installation, place each handset in the telephone base or a charger and allow
to charge for 16 hours before use. You can keep the battery packs charged by returning
the handsets to the telephone base or chargers after each use. When the battery is fully
depleted, a recharge takes about 12 hours. The average talk time on a fully charged battery
is about eight hours depending on environmental conditions, standby time is approximately
four days.
Plug the battery
pack connector
into handset.
Place handset in base or
charger to charge for 16
hours before first use.
Plug power adapter into the jack
on the underside of charger as
shown, then plug into electrical
outlet.
Caution: Use only supplied rechargeable battery or replacement battery pack (part number 80-5848-00-00).
Press in and downward on
the tab to open the battery
compartment cover.
Slide battery compartment
cover up until it clicks closed.
NOTE: Use only the power cord supplied with this product. If you need a replacement, call 1 (800) 222-3111. In
Canada, call 1 (866) 288-4268. Be sure to use an electrical outlet not controlled by a wall switch.
Low battery indicator
Return handset to base
or charger to recharge
when this symbol flashes.
(Handset will beep when
battery is low.)
LOW BATTERY
Place the battery
pack and wires in
the compartment.