AT&T CL84250 Telephone User Manual


 
77
Troubleshooting
My cordless handset isn’t performing normally.
Make sure you plug the power cord securely into the telephone base.
Plug the power adapter into a different, working electrical outlet without a
wall switch.
Move the cordless handset closer to the telephone base. You might have
moved out of range.
Reset the telephone base. Unplug the electrical power. Wait for 15
seconds then plug it back in. Allow up to one minute for the cordless
handset and telephone base to reset.
Other electronic products can cause interference to your cordless phone.
Try installing your phone as far away from these types of electronic
devices as possible: television sets, VCRs, or other cordless telephones.
Out of range OR No pwr at base appears on my cordless handset.
Ensure you plug the telephone base in properly and the power is on.
Place the cordless handset closer to the telephone base for synchronization.
Move the cordless handset closer to the telephone base. You might have
moved out of range.
Reset the telephone base. Unplug the electrical power. Wait for 15
seconds then plug it back in. Allow up to one minute for the cordless
handset and telephone base to reset.
Other electronic products can cause interference with your cordless
phone. Try installing your phone as far away from these types of electronic
devices as possible: television sets, VCRs, or other cordless telephones.
The batteries do not hold a charge.
If the cordless handset is in the handset charger and the charge light
is not on, refer to The charge light is off or blinking (page 80) in this
Troubleshooting guide.
Charge the battery in the cordless handset for at least 16 hours. For
optimum daily performance, return the cordless handset to the charger
when not in use.
If the battery is depleted, it might take approximately 30 minutes to charge the
handset before it shows Low battery, refer to the table on page 7 for details.
You might need to purchase a new battery. Please refer to Battery
installation and charging in this user’s manual on pages 7-8.
Appendix