Filter
Top Products
69
Adding and registering handsets
When first purchased, all expansion handsets show Out of
range OR No pwr at base on the screen. The new handset
should be charged without interruption for at least 30
minutes before registering to the telephone base.
To register a handset to your telephone base
1. Make sure the handset is out of the charger and alternately
shows 1.Press HS LOC on base 4sec and 2.Then press #
on handset before you begin the registration.
2. Press and hold LOCATOR on the telephone base
for about four seconds (until the base screen shows
Registering handset...) and then release the button.
3. Press # on the handset. The screen shows Registering...
Please wait. It takes up to 60 seconds to complete the
registration. Then HANDSET X Registered appears on the
screen, with X being the handset number (1-12) and the
handset beeps. The handset is now registered with the
telephone base.
If the registration is not successful, the handset screen
displays Registration failed appears on the screen.
Please start again from step 1 above.
NOTE: You cannot register a handset if any other system handset
is in use.
HANDSET X
Registered
Out of range OR
No pwr at base
1.Press HS LOC
on base 4sec
2.Then press #
on handset
Registering...
Please wait
Appendix
Registering
handset...
HANDSET X
Registered