Filter
Top Products
5
Getting started
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at www.telephones.att.com or call
1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.
2. The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
PRESS TO RELEASE
PRESS TO RELEASE
Telephone base installation
Install the telephone base as shown below.
The telephone base is ready for tabletop use. If you want to change to wall
mounting, see page 9 for details.
Plug the small end
of the AC power
adapter into the
power jack on
the bottom of the
telephone base.
•
Plug one end of
the telephone
line cord into the
telephone jack on
the bottom of the
telephone base.
•
Place the cords into
the channels.
•
Plug the other
end of the
telephone line
cord into a
telephone jack or
a DSL filter.
•
Plug the other
end of the coiled
handset cord into
the jack at the left
of the telephone
base.
•
Raise the
antenna.
•
Plug the large end of
the AC power adapter
into a power outlet
not controlled by a
wall switch.
•
If you have DSL high
speed Internet service,
a DSL filter (not
included) is required.
NOTE: This telephone provides minimal functionality during a power outage. When AC
power is not available, many telephone features do not function. The telephone uses power
from the telephone line to enable you to make and answer calls using only the corded
handset and dial pad keys. However, when more than one telephone on the same line is
being used simultaneously, there might not be sufficient power to operate your telephone in
the event of a power failure.