AT&T 993 2-Line Telephone User Manual


 
13
Getting started
Wall mounting
A wall jack with mounting studs is required for wall mounting. This wall jack
with mounting studs may be available for purchase from a hardware store or
consumer electronics retailer and may require professional installation.
Rotate the mounting bracket.
The mounting bracket should be set into the downward position as shown
below.
1.
Connect the power cord to the telephone.
Plug the smaller end of the power adapter into the jack labeled 9V AC
POWER on the back of the telephone. Route the cord through the slot,
bundle the cord and secure it with a twist tie if necessary. Plug the other
end of the power adapter into an electrical outlet not controlled by a wall
switch.
3.
Reverse the handset tab.
Hold down the switchhook, and slide the tab up and out of its slot. Turn
the tab so that the end with the hook points up, then insert the tab back
into its slot.
The handset can now be held securely in place when the telephone is wall
mounted.
2.
POWER jack
slot
Electrical outlet not
controlled by a wall
switch