Filter
Top Products
• If you have two separate jacks,plug the free end of the cord
with the blue plugs into the modular wall jack for Line 1.
Plug the free end of the cord with the clear plugs into the
modular wall jack for Line 2. Make sure the cords snap firmly
into place.
4 Connect the handset to the telephone.
Plug the coiled cord into the handset jack on the side of the
phone. Plug the other end of the coiled cord into the handset,and
then hang up.
5 Connect the power cord.
CAUTION: Use only the power cord supplied with this phone.
If you need a replacement cord, call 1 800 222-3111.
Fit the power cord behind the strain relief tab. Then plug the
smaller end of the power cord into the jack labeled POWER at
the back of the system. Plug the power cord into a standard
electrical outlet not controlled by a wall switch.
6 Check for dial tone.
Press L, then lift the handset or press S and listen for a
dial tone. Then press l and listen for a dial tone. If you do not
hear a dial tone, see IN CASE OF DIFFICULTY.
7 Confirm Lines 1 and 2.
Press L and call one of your phone numbers. If you hear a
busy signal, you called Line 1. If you hear a ringing signal in the
receiver, then you called Line 2.
8 Select Display Language.
The screen displays ENGLISH (flashing) and ESPANOL. The flashing
language is the selected language. Use CALL LIST + or CALL LIST
- to select the other language, then use the softkey to select OK.
6
INSTALLATION
AC
Adapter
Power
Cord
Telephone Line
Cord with blue
modular plugs
Telephone Line Cord with
clear modular plugs
Modular
Jack for
Line 1
Modular
Jack for
Line 2
972_00_1ATT BOOK 12/4/01 1:37 PM Page 6