Filter
Top Products
4
Battery Installation
Before using the telephone, install a 9V battery (not included). In case
of a power failure, you will be able to use the phone normally if a fresh
9V battery is installed, but Caller ID information will not be displayed. This
phone has a Memory Loss protection feature and will store your caller ID
information, memory and programmed settings until power is restored.
When battery power is low,LOW BATT shows on the display to alert you.
Replace batteries promptly.
CAUTION: Always disconnect all cords and remove base before
installing new batteries.
1 Remove the label covering the display screen.
2 Turn the telephone upside down.
3 Remove the base (Figure 1).
Place your thumbs in the two openings at the large end of
the base. Push down with your thumbs, and lift the base up
and away from the phone.
4 Open the battery compartment door (Figure 2).
Press on the tabs and remove the door.
5 Install one new 9V battery (Figure 3).
6 Replace the battery compartment door.
7 Turn to Step 1 in “Table/Desk Installation” or “Wall Installation”.
INSTALLATION
Figure 2
Figure 3
Figure 1
972_00_1ATT BOOK 12/4/01 1:36 PM Page 4