Filter
Top Products
5
Table/Desk Installation
Note: Be sure to follow the steps below in order. Do not plug the phone
into electrical power until all the cords are properly connected to the
phone.
1 The base.
Turn the base so the larger end is toward the top of the telephone.
Attach the base by inserting the tabs into the slots. Push down on
the large end of the base to lock it into place.
2 Connect the line cord(s) to the telephone.
• If you have a two-line jack, use only a line cord with clear
modular plugs on each end. Plug one end into the jack
labeled L1 OR L1/2 on the back of the telephone.
• If you have two separate jacks,use two line cords. Insert
one end of a cord with blue plugs into the jack labeled L1
OR L1/2 on the back of the telephone. Insert one end of
the cord with clear plugs into the jack labeled L2 on the
back of the telephone.
3 Connect the line cord(s) to your modular jack(s).
• If you have a two-line jack, plug the free end of the line cord
into a modular wall jack. Make sure the cord snaps firmly
into place.
INSTALLATION
AC
Adapter
Power
Cord
Telephone Line
Cord with clear
modular plugs
Two-line
Modular
Jack
972_00_1ATT BOOK 12/4/01 1:36 PM Page 5