Filter
Top Products
B AT T E R I E S
About the Handset Batteries
You will know the batteries need
charging when:
• The phone beeps two times when
you press to answer or
make a call.
• The LOW BATT indicator on the
handset flashes.
• The phone does not respond when
you press and the PHONE
indicator does not go on.
Charging the Handset Batteries
Place the handset in the base so the
IN USE/CHARGE indicator goes on.
The batteries will be fully charged in
16 hours. Once the batteries are fully
charged, you need only put the hand-
set in the base when the LOW BATT
indicator flashes.
If it is more convenient for you to do
so, you can leave the handset in the
base all the time. It is impossible to
overcharge the batteries.
If the bat t e r ies don’t ch a r ge pro p e r ly :
If you get a low-battery signal even
after 16 hours of charging, the
battery should be replaced.
CAUTION: To reduce the
risk of fire or injury to
persons or damage to the telephone,
read and follow these instructions
carefully.
• Use only Replacement Battery
3470.
• Do not dispose of the battery
in a fire. The cell might explode.
Check with local codes for special
disposal instructions.
• Do not open or mutilate the
battery. Released electrolyte is
corrosive and may cause damage
to the eyes or skin. It may be toxic
if swallowed.
• Exercise care in handling batteries
in order not to short the battery
with conducting materials such
as rings, bracelets, and keys. The
battery or conductor may overheat
and cause harm.
• Charge the battery provided with
or identified for use with this
product only in accordance with
the instructions and limitations
specified in this manual.
• O b s e rve proper polarity ori e n t at i o n
between the battery and battery
charger.
Replacing the Battery Pack
1 R e m ove the bat t e ry compart m e n t
c over on the handset by pressing on
the indentation and sliding the
c over dow n wa rd.
2 Lift out the old battery pack.
3 Place the battery pack in the
compartment. Make sure the
metal contacts on the underside
of the battery are aligned with the
charging contacts in the battery
compartment.
4 Replace the cover by sliding it
on its track up over the battery
c o m p a rtment until it snaps firmly
in place.
5 The new batteries must be charged
before using your telephone. Place
the handset in the base unit and
allow it to charge for 16 hours.
The telephone may operate before
that but, for best performance, let
the batteries charge fully.
See illustration on next page.
Spare Battery Charger
The Cordless Telephone 9105 is
equipped with a spare battery charger
built-in to the base unit. The spare
battery charger allows you to always
have a charged battery available,
should your handset battery
discharge during normal use.
To install the Spare Battery Pack
(PURCHASED SEPARATELY):
1 Open the base unit bat t e ry
c o m p a rt m e n t .
2 Place the spare battery pack in
the battery compartment. Make
sure the metal contacts on the
underside of the battery are
aligned with charging contacts
in battery compartment.
3 R eplace the bat t e ry compart m e n t
c ove r.
4 When the bat t e ry is installed
p ro p e rly, the SPA R E BAT T E RY
i n d i c ator on the base unit will be
i l l u m i n at e d.
5 The spare battery will be fully
charged after 16 hours. Please
note that the SPARE BATTERY
i n d i c ator will always be illuminat e d
when a spare battery is installed.
Spare Battery
Charger
Charging
Contacts
SPARE BATTERY
indicator
6