Filter
Top Products
M E M O RY
Memory Features
This telephone can store 10 telep h o n e
nu m b e rs , e a ch up to 16 digits long.
Numbers will remain stored in
memory unless you erase or change
them by entering other numbers.
Programming a Number
into Memory
Make sure the handset is .
1 Press . The PHONE indica-
tor will blink to indicate that you
are in the programming mode.
2 Enter a number button (0-9).
3 Enter the phone number
(up to 16 digits).
4 Press to store the phone
number to the key you selected.
The phone now exits mode
and emits a tone.
NOTE: You may choose to store
emergency numbers in memory
locations. The manufacturer assumes
no responsibility for customer
reliance upon this memory feature.
Dialing a Number Stored in Memory:
1 Press to get a dial tone.
2 Press .
3 P ress the number button (0-9) yo u
assigned to that phone nu m b e r.
For example, to dial the phone
number you assigned to button
“6”, press , , .
IN USE/CHARGE Indicator
When the handset is in the base
cradle, the IN USE/CHARGE
indicator increases intensity with
each ring of the incoming call. When
the handset is not in the base, the
IN USE/CHARGE indicator flashes
steadily. After the call is answered,
the IN USE/CHARGE indicator will
remain lit until the end of the call.
Memory Card
There is a memory card with an
erasable surface located on the
base to record names or telephone
numbers of the numbers stored in
memory locations.
Programming a Pause Into a Memory
Dial Phone Number
When programming a number into
memory, store the access number and
a pause into the number sequence.
The pause will allow the switchboard
enough time to give you an outside
line dial tone.
To insert a pause in a stored nu m b e r,
p ress and hold down the key that
comes befo re the pause, until you hear
a second beep. This inserts a 2-second
pause after that digit. To insert a
l o n ger pause, hold the key down until
you hear a third or fo u rth beep. Each
time you hear another beep , it make s
the pause 2 seconds longe r.
For example, to store 9, PAUSE,
555-1234: Press and hold it
until you hear a second beep.
Then press .
NOTE: Each pause you program
is counted as a digit. You can
program up to 16 digits in each
memory location.
Changing or Replacing a
Stored Number
You can change or replace a stored
number by storing a new number in
its place.
Page/Handset
Locator
POWER indicator
goes on when the
base power adapter
is plugged into an
electrical outlet.
Base Antenna
Spare Battery Charger
(under Memory Card)
SPARE BATTERY
indicator goes on
when you are
charging a
spare battery.
IN USE/CHARGE
indicator—see
description above.
Memory Card
5