Filter
Top Products
Caller ID Feature Setup
You can set up Caller ID features at the handset right after setting up the
final Telephone feature (Handset Ringer), by programming your Home Area
Code. Otherwise, follow Steps 1-4 in “Telephone Feature Setup” on page 8
to begin setting up Caller ID features.
Program Home and Local Area Codes
Your “home area code”is usually the area code from which you are dialing.
“Local area codes”are area codes for which you must dial an area code but
not “1.” Always program your home area code, and, if you need them, up to
four local area codes to allow for correct operation of the Display Dial
feature (see page 39).
NOTE: Do not select CHANGE. Instead, when screen displays
AREA CODE 1:
1 Use the keypad to enter your home area
code (AREA CODE 1).
2 Select CODE 2 to reach AREA CODE 2 (the
screen displays any current local area code
stored here). Use the keypad to enter a
three-digit local area code.
3 Continue as in Step 1 for area codes 3, 4
and 5 as needed.
4 Select DONE when finished.
Caller ID with Call Waiting
You must subscribe to Caller ID with Call Waiting
service (a combined service) in order for this
feature to work. If you don’t have Caller ID with
Call Waiting service, turn this feature off.
Call List Options
Choose whether the system stores information
about ALL CALLS received, or for NO CALLS.
FEATURE SETUP
9
AREA CODE 1:000
CODE 2 DONE
LIST:NO CALLS
CHANGE DONE
LIST:ALL CALLS
CHANGE DONE
CIDCW: OFF
CHANGE DONE
CIDCW: ON
CHANGE DONE