AT&T 7610 Cordless Telephone User Manual


 
BATTERIES
3
Charging the
Handset Battery Pack
The batteries need charging when:
The phone beeps four times when you
press P.
The LOW BATTERY light on the
handset flashes on and off.
The phone does not respond when you
press P, and no lights go on.
Place the handset in the base so the
CHARGING light goes on. The batteries
will be fully charged in 14 hours.
NOTE: The handset must lie flat in the
base, with the keypad facing down, when
charging. The charging light in the base goes
on if the handset is positioned correctly.
A fully charged battery maintains standby
power for up to 14 days when the Handset
Ringer ON/OFF switch is set to ON, and up
to 21 days when the Handset Ringer ON/OFF
switch is set to OFF.
If it’s more convenient for you, you can leave
the handset in the base all the time.
It is impossible to overcharge the batteries.
If you get a low battery indicator even after
the batteries have been charged 14 hours, the
battery should be replaced.
Battery Case
Wires
Battery Pack
Battery Pack
Wires
Battery Case Cover
Battery Case Cover
CAUTION: To reduce the risk of
fire or injury to persons or
damage to the telephone, read and
follow these instructions carefully.
Use Replacement Battery 4051 in the
handset.
Do not dispose of the battery in a fire.
The cell might explode.
Do not open, puncture or mutilate the
battery. Released electrolyte is
corrosive and might cause damage to
the eyes or skin. It might be toxic if
swallowed.
Replacing the Handset
Battery Pack
1 Remove the battery case cover on
the handset by pressing on the
indentation and sliding the cover
downward.
2 Lift out the old battery pack and
unplug it from the handset.
3 Hold the new battery pack and plug
the connector into the handset.
Place the battery pack into the case, so
the wires rest above the battery pack.
4 Replace the cover by sliding it on its
track up over the battery case until it
snaps firmly into place.
5 The new batteries must be charged
before using the phone. Place the
handset face down in the base and
allow it to charge for 14 hours. The
telephone might operate before that,
but for best performance, let the
handset batteries charge fully.