AT&T 2448 Telephone User Manual


 
11.
12.
13.
Unplug this product from the wall outlet and refer servicing to qualified service
personnel under the following conditions:
• when the power supply cord or plug is damaged or frayed.
• if liquid has been spilled into the product.
if the product has been exposed to rain or water.
• if the product has been dropped or the housing has been damaged.
if the product exhibits a distinct change in performance.
Avoid using a telephone during an electrical storm. There may be a remote risk
of electric shock from lightning.
Do not use the telephone in the vicinity of a gas leak. To report a gas leak, use
a telephone away from the area of the leak.
Basic safety precautions should always be followed when your telephone equipment is
installed.
WARNING: The SPIRIT Communications System, Model 2448 must be installed by
an AT&T service technician or a qualified installer.
WARNING: If you need to install a SPIRIT Communications System telephone in a
different building but not more than 1000 feet from the control unit, In
Range-Out of Building (IROB) protectors, AT&T Order Number 31304
(TII Model 371 or ITW Model SP69073), are required. The IROB
protectors must be installed by an AT&T service technician or a qualified
installer. Contact your AT&T representative for additional information.
1.
2.
3.
4.
5.
Never install telephone wiring during a lightning storm.
Never install telephone jacks in wet locations unless the jack is specifically
designed for wet locations.
Never touch uninsulated telephone wires or terminals unless the telephone line
has been disconnected at the network interface.
Use caution when installing or modifying telephone lines.
Do not attach the power supply cord to building surfaces.
SAVE THESE INSTRUCTIONS