Filter
Top Products
If the caller’s name or phone number is not displayed during
Call Waiting:
• You should call your service provider to confirm that you subscribe to
a combined Caller ID with Call Waiting service.
• Caller ID information received during Call Waiting is displayed only on
the handset that is in use. The information is stored in the Caller ID log
on both handsets.
• Make sure the battery is charged.
If you are unable to operate special telephone services or other
equipment requiring touch tone signals:
If you have dial pulse (rotary) service, follow the directions under
“Temporary Tone Dialing”in the TELEPHONE OPERATION section of
this manual.
If messages are incomplete:
• If a caller leaves a very long message, part of it may be lost when the
system disconnects the call after three minutes.
• If the caller pauses for more than seven seconds, the system stops
recording and disconnects the call.
• If the system’s memory becomes full during a message, the system
stops recording and disconnects the call.
If you have difficulty hearing messages:
Check the volume setting.
If callers are unable to leave messages in Mailbox 2 or 3:
Re-record your outgoing announcement leaving several seconds of blank
time at the end of your announcement to allow callers enough time to
select a mailbox.
If the system does not answer after the correct number of rings:
• Make sure that the answering system is on.
• If Toll Saver is on, the number of rings changes to two when you have
new messages waiting.
• In some cases, the system may be affected by the ringing system used
by the local telephone company.
• If the memory is full or the system is off, the system answers after
10 rings.
If CL appears in the Message Window:
You need to reset the clock.
IN CASE OF DIFFICULTY
29