Filter
Top Products
Answering System Feature Setup
You can set up one feature at a time,or you can set up a feature and then
move on to set up another feature.
1 Make sure the answering system is on.
2 Press and release U until you hear the system announce the
feature you want to set. Refer to the “Feature Summary” below for a
description of the features and your choices.
3 Press S to hear the feature’s settings.
4 Press t to confirm your selection.
Feature Summary
Default settings indicated by
*
.
System announces: Description/directions:
“Change remove access code” Set the remote access code you will use
19
*
to access features and functions of the
answering system from a touch tone phone.
“Change clock” Set the clock: After you set the day,repeat
Steps 3 and 4 in “Answering System
Feature Setup”to set hours and minutes.
“Change message alert” When Audible Message Alert is turned on,
Off
*
the base beeps once every 10 seconds
On when new messages have been received.
“Change announce only” When you turn Announce Only on, callers
Off
*
hear your announcement but cannot
On leave a message.
“Change base ringer” Turn the base ringer on or off.
On
*
Off
“Change number of rings” Choose how many times the phone will
2 ring before the system answers a call.
4
*
With Toll Saver active,the system answers
6 after two rings when you have new
Toll Saver messages and after four rings when you
have no new messages.
NOTE: Exit Feature Setup at any time by pressing a MAILBOX/STOP button.
ANSWERING SYSTEM OPERATION
AT THE BASE
20