Filter
Top Products
3
INITIALIZATION ERROR MESSAGES
Once you have completed all the connections successfully, the indicator lights on the
upper right-hand corner of the AT&T VoiceMail Manager 200 should flash once, and
the display will show INITIALIZING – PLEASE WAIT. The AT&T VoiceMail Manager
200 will run through a brief initialization process and then display NO CALLS.
During initialization, the AT&T VoiceMail Manager 200 may display one of several
error messages:
☎ PLUG IN THE PHONE LINE – This message will be displayed if the initialization
fails because the AT&T VoiceMail Manager 200 cannot detect a phone line
connected to it. Check your connections and make sure the line is free.
☎ SWAP PHONE AND LINE – This message will be displayed if the initialization
fails because the line from the wall jack is connected to the wrong ports on the
AT&T VoiceMail Manager 200. Disconnect the power cord and make sure the
lines are connected to the proper ports. Reconnect the power to restart the
initialization.
☎ NO DIAL TONE – This message will be displayed if the initialization fails
because the AT&T VoiceMail Manager 200 cannot detect a dial tone. Check
your connections and make sure the telephone line is free.