Filter
Top Products
16
USING THE AT&T MESSAGE SCREENING FEATURE
☞ Refer to Figure 5 on Page 15.
The AT&T Message Screening feature of the VM200 was activated during power up.
When AT&T Message Screening is activated, the light next to the VM
SCREEN key
(Key 2 on Figure 5) should be illuminated. If you wish to deactivate AT&T Message
Screening, simply press the VM
SCREEN key and the light will go off. To reactivate
AT&T Message Screening, press the VM SCREEN key, and the light will come back
on.
The VM200 is able to screen your incoming calls by using Three-Way Calling and
AT&T VoiceMail. Working in conjunction with these two services, the VM200’s built-in
speaker allows you to listen to callers while they leave you an AT&T VoiceMail
message. Caller Identification information will also be displayed at this time. This
information will automatically be added to your calls list as discussed in Viewing
Calls/Caller Identification, section.
While screening a message, If you wish to adjust the volume of the speaker, use the
REVIEW
keys. The ▲ key will increase the volume, and the ▼ key will decrease the
volume.
☞ While you are screening a message, if you decide you want to speak to the
caller, simply pick up the handset of your telephone and you will
automatically be connected.