Filter
Top Products
TELEPHONE OPERATION
Dial Mode
This phone comes set to operate with touch
tone service. If you have dial pulse (rotary)
service, you will need to reset the dial mode.
If you hear clicks (not tones) when you dial,
you have dial pulse (rotary) service.
6
To change to dial pulse mode:
1 Press and release G.
2 Press #, #, #, 3.
To change back to touch tone mode:
1 Press and release G.
2 Press #, #, #, 8.
Redial
Press and release R to dial the
last number you dialed. The last
number you dialed (up to 24
digits) is stored in redial memory
until you dial another number.
Making/Answering Calls
1 Lift the handset or press
K.
2 To end a call, hang up or
press K.
3 To switch from handset to
speakerphone, press
K, then hang up. To
switch from speakerphone
to handset, lift the handset.
Ringer Volume
While not on a call,
use VOLUME + or -
to adjust the ringer
volume. Setting to
lowest level turns the
ringer off. You will
hear a three-beep
tone when the ringer
is turned off or set to
highest level.
Handset/
Speakerphone
Volume Control
While on a call or
listening to messages,
use VOLUME + or -
to adjust the listening
level. Press the top
arrow to increase
volume. Press the
bottom arrow to
decrease volume.
Mute
To mute a call, press and
release m. The MUTE light
goes on.
To return to two-way
conversation, press and
release m.
Mute is canceled if you switch
from handset to speakerphone
or from speakerphone to
handset.
Flash
Press and release
F instead of
pressing the
switchhook to
activate telephone
company subscriber
services such as Call
Waiting or Three-Way
Calling.
Hold
To put a call on hold, press
and release H. The LINE
STATUS light will blink when a
call is on hold.
To take a call off hold, press
and release H
— OR —
Press K
— OR —
Lift the handset of
this phone
— OR —
Lift the handset of
another phone on
the same line.
Temporary Tone
NOTE: If you have touch tone service, you
do not need to use the Temporary Tone
feature.
1 Dial the call, then press and release *.
Any buttons pressed after this send
touch tone signals.
2 After you hang up, the phone
automatically returns to dial pulse
(rotary) dialing.