Filter
Top Products
31
If messages are incomplete:
• If a caller leaves a very long message, part of it may be lost when the
system disconnects the call after three minutes.
• If the caller pauses for more than seven seconds, the system stops
recording and disconnects the call.
• If the system’s memory becomes full during a message, the system
stops recording and disconnects the call. Check that all old messages
have been deleted by pressing an MBOX/STOP button.
If you have difficulty hearing messages:
Check the volume setting.
If the system does not answer after the correct number of rings:
• Make sure that the answering system is on.
• If Toll Saver is on, the number of rings changes to two when you have
new messages waiting.
• In some cases, the system may be affected by the ringing system used
by the local telephone company.
• If the memory is full or the system is off, the system answers after
10 rings.
If CL appears in the Message Window:
You need to reset the clock.
If the system does not respond to commands from a remote
ouch tone phone:
• Make sure you are calling from a touch tone phone. When you dial a
number, you should hear tones. If you hear clicks instead, the phone is
not a touch tone telephone.
• The answering system may not detect the Remote Access Code while
your announcement is playing. Try waiting until the announcement is
over before entering the code.
• Make sure you enter your Remote Access Code correctly.
• There may be noise or interference on the phone line you are using.
Press keys firmly.
IN CASE OF DIFFICULTY
1480_book_1ATT 2/25 2/25/02 10:30 AM Page 31