Filter
Top Products
7
INSTALLATION
Handset Charger Installation
1 Connect the power cord. Feed the
power cord through the strain-relief
channel on the bottom of the handset
charger. Then plug the cord into an
electrical outlet not controlled by a
wall switch.
CHARGING
Light: on
when
handset is in
charging
stand
2 Install the handset battery.
Use only AT&T Replacement Battery 3301, SKU# 91076.
b) Align two holes in
plug with socket
pins, and snap the
plug into place.
d) Replace cover by
sliding it up into
place.
a) Remove battery
compartment
cover by pressing
on the
indentation
and sliding
downward.
c) Place battery pack in
compartment with
the wires in the
lower left corner,
along the bottom of
the battery pack.
1480_book_1ATT 2/25 2/25/02 10:30 AM Page 7