25 26
3) Use the 5, or b to scroll through the
possible call signal sounds [CAL 0] ~ [CAL
5].
4) Once the desired Call signal has been
selected, press the ENTER button to save.
BEEP Sound / Silent Mode Setting
1) Press and release the [F] button 6 times to
enter the beep sound setting or silent mode
(no beep sounds from radio).
2) The display will blink “bP ON” or “bP OFF”.
3) Use the 5, or b to select “bP ON” or “bP
OFF”.
4) Once selected, press the ENTER button to
save.
NOTE: When beep is active, the “musical note”
icon will be displayed.
“Roger” Beep Function
This function transmits a “beep” tone upon
release of the P-T-T button, alerting the party
you have called that your message is
complete.
1) Press and release the [F] button 7 times to
enter the “Roger Beep” setting.
2) The display will blink “rb ON” or “rb OFF”.
3) Use the 5, or b button to select “rb ON” or
“rb OFF”.
4) Once selected, press the ENTER button to
save.
VOX Function
VOX (Voice operated transmission) is a
function which allows you to talk without
pressing the P-T-T button. Your voice “sends”
the message instead. To activate VOX:
1) Press and release the [F] button 8 times to
enter VOX setting.
2) Use the 5, or bbutton to select “Vo on”.
3) Press the Enter button to adjust the VOX
Sensitivity.
4) “SEN 1” will be blinking in the display.
5) Use the 5, or b button to select “SEN 1” ~
“SEN 10”. The “SEN 1” setting is the most
sensitive, “SEN 10” is the least sensitive.
6) Once the desired sensitivity setting is
selected, press the ENTER button to set the
VOX Delay (dLY).
