23 24
To return to the channel number display, press
the [F] and ENTER buttons at the same
time again.
NOTE: When the radio is set to display by
frequency, Channel and CTCSS sub-code
programming will also display by channel
frequency and sub-code frequency as
referenced on the Channel Frequency List and
CTCSS Sub-Code Frequency List.
Dual Channel Scan Function
This function allows you to alternately scan
between two selected channels.
1) Press and release [F] button once and use
5, or b to select the first of the two
channels.
2) Once the channel has been selected, press
and release the [F] button 2 more times,
(“DCH OFF” will be blinking in the display).
3) Use 5, or b to select the second scan
channel.
4) Press and release the ENTER button to
store the two scan channels, and enter the
dual channel scan mode. The radio will
now begin scanning between the two
selected channels.
5) To cancel the dual channel scan function,
press and release the MON button.
HI/LOW Transmit Power
1) Press and release the [F] button 4 times to
enter the HI/LOW power setting.
2) The display will blink either “tPr Hi” (transmit
power high) or “tPr Lo” (transmit power low).
3) Use the 5, or b button to select “tPr Hi” or
“tPr Lo”. Press the ENTER button to save.
Low power is useful for extending the life of
your batteries and should be used at close
distances.
NOTE: Channels 8~14 are permanently set to
“tPr Lo” and cannot be changed due to FCC
regulations.
CALL Signal Settings
1) Press and release the [F] button 5 times to
enter the CALL signal setting.
2) The display will blink “CAL 1”.
