A SERVICE OF

logo

17
When monitoring pictures of a camera with two or more monitors
Use the CGI command to designate pictures of the camera to be displayed on the monitors.
Send the CGI command to each decoder and set the receiving IP address of the camera whose pictures are to be
displayed on the monitors. Refer to the "SWITCHING STREAMING VIDEO" section of "HOW TO USE THE CGI
COMMANDS" on page 90.
Refer to the following pages for further information related to the system above.
Encoder: NETWORK page (page 56), VIDEO page (page 44)
Decoder: NETWORK page (page 73), VIDEO page (page 69)
It may be required to change the network settings of a PC to switch streaming video.
OPERATE
STATUS
MPEG2 Encoder WJ-GXE
900
1 2 3 4 5 6 7 8
OPERATE
1
ACT1000100LINK1
STATUS
2 3 4 5 6 7 8
MPEG3 Decoder WJ-GXD
900
OPERATE
1
ACT1000100LINK1
STATUS
2 3 4 5 6 7 8
MPEG3 Decoder WJ-GXD
900
OPERATE
1
ACT1000100LINK1
STATUS
2 3 4 5 6 7 8
MPEG3 Decoder WJ-GXD
900
VIDEO IN
MPEG2 Encoder
MPEG2 Decoder 1
MPEG2 Decoder 2
MPEG2 Decoder 3
100BASE-TX
Switching hub
(100Mbps/1000Mbps compatible)
Camera 1
Monitor 1
Monitor 2
Monitor 3
1
VIDEO OUT
VIDEO OUT
VIDEO OUT
1
1
1
PC
10BASE-T/
100BASE-TX