Troubleshooting
66
Problem
“No link to base.
Walk closer to base &
try again” is displayed on
the cordless handset display
and an alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The cordless handset does
not ring.
The cordless handset
display is blank.
You cannot store a name
and phone number in the
directory.
While programming or
searching, the unit starts to
ring and stops the
program/search.
Cause and Remedy
≥You are too far from the base unit.
Move closer and try again.
≥Raise the base unit antennas.
≥Plug in the AC adaptor of the base unit.
≥The cordless handset may lose
communication with the base unit.
Set the security code (p. 59).
≥Locate the cordless handset and the
base unit away from other electrical
appliances (p. 3).
≥Move closer to the base unit.
≥Raise the base unit antennas.
≥Press (fi) to select a clearer channel in
the talk or intercom mode.
≥The ringer volume is set to OFF. Set to
HIGH or LOW (p. 20).
≥Charge the battery fully (p. 11).
≥You cannot store an item in the
directory while the base unit is in the
talk or intercom mode.
≥Do not pause for over 60 seconds while
storing.
≥To answer the call, press . Start
again from the beginning after hanging
up.
Cordless handset
