“
One-Touch Dialer
48
5
Press (fl) (Yes key).
6
Enter a phone number, up to 22 digits.
≥Each time you press (CLEAR), a digit is
erased. To erase all of the digits, press and
hold (CLEAR).
≥To move the cursor, press (fi) or (fl).
7
Press (›) (Next key).
8
Press (fl) (Save key).
≥A beep sounds.
≥To store other numbers, repeat from step 4.
≥To exit the programming mode, press (EXIT).
≥If a pause is required for dialing, (PAUSE) can be stored in a phone number
counting as one digit (p. 57) in step 6.
≥You can exit the programming mode any time by pressing (EXIT).
To erase a stored number
Repeat steps 1 through 5 ¤ press and hold (CLEAR) until all of the digits
are erased ¤ (›) (Next key) ¤ (fl) (Save key).
Dialing
(Base\Unit)
1
Press the required DIRECT button ((DIRECT1), (DIRECT2) or
(DIRECT3)).
≥If 3 beeps sound, you have not stored the phone numbers in the DIRECT
buttons. Store the number.
≥The DIGITAL SP-PHONE indicator lights.
≥The stored number is dialed.
≥Numbers stored in the base unit can only be dialed by the base unit.
≥You can also dial the stored number by pressing (DIGITAL\SP-PHONE) or lifting
the handset then pressing the DIRECT button.
1234567890¢P
3
=Edit
1
=Save
1234567890¢P
Save DIRECT2
21
4
=Next
1234567890¢P
21
4
=Next
