FC Daughter Card Functional Description
RTM-ATCA-7350 Installation and Use (6806800H30F)
49
Optical modules are used to provide the optical interfaces at the face plate. See Connecting
Optical Fibers on page 36 for installing the optical modules. Optical modules for the FC
daughter card must be obtained separately. Recommended modules are FINISAR
FTRJ8519P1BNL-HW. FINISAR FTRJ8519P2BNL-HW.
The following figure shows the FC daughter card.
Indicators
The FC daughter card provides the RUN and ALM indicators. You can monitor these indicators
to diagnose the current status of the external FC interfaces.
The following table lists the two indicators provided by the FC daughter card.
Figure 4-3 FC Daughter Card
Table 4-2 Indicators Provided by the FC Daughter Card
Indicator Color Meaning Description
ALM Amber FC interface working
state
z Green on and amber on: RTM-ATCA-7350 is in
the power-on process.
z Green off and amber blinking: Signal
synchronization is lost.
z Green off and amber on: The interfaces are
obtaining signals.
z Green on and amber off: The interfaces are
ready for processing signals.
z Green blinking and amber blinking: A fault
occurs in the firmware.
RUN Green
