FC Daughter Card Hardware Preparation and Installation
RTM-ATCA-7350 Installation and Use (6806800H30F)
29
2.6.4.2 Installing the FC Daughter Card
To install the FC daughter card, proceed as follows.
1. Wear the ESD-preventive wrist strap. For more information refer, Wearing the ESD-
Preventive Wrist Strap on page 21.
2. Lay RTM-ATCA-7350 where the FC daughter card is to be installed on the antistatic
desktop.
3. Insert two plastic supports vertically in the holes used to fasten the FC daughter
card.
4. At the back side of RTM-ATCA-7350, use a screwdriver to clockwise fasten the two
screws used to fix the plastic supports.
5. Take the FC daughter card out of the antistatic package.
6. Insert the FC daughter card in RTM-ATCA-7350 by facing the daughter card at an
angle of 45° to the RTM. Align the daughter card connector with the connector on
RTM-ATCA-7350, and the daughter card positioning holes with the plastic supports
on RTM-ATCA-7350. Exert even power downwards until the daughter card
connector is fully inserted into the connector on RTM-ATCA-7350 and the daughter
card is fastened by the plastic latches.
7. Insert
RTM-ATCA-7350 with the FC daughter card installed in the shelf. For more
information refer, Installing RTM-ATCA-7350 on page 30.
After installation, check if RTM-ATCA-7350 can be powered on and work normally. Use the
optical fiber to connect RTM-ATCA-7350 to the external storage system. Check if RTM-ATCA-
7350 can transmit data normally and monitor whether the FC status indicator is normal.
2.6.4.3 Replacing the FC Daughter Card
To replace the FC daughter card, proceed as follows.
1. Wear the ESD-preventive wrist strap. For more information refer, Wearing the ESD-
Preventive Wrist Strap on page 21.
2. Remove the
RTM-ATCA-7350 whose FC daughter card is to be replaced. For more
information refer, Removing RTM-ATCA-7350 on page 32.
3. As shown in step 1 of the figure below, open the plastic latches fastening the FC
daughter card.
4. Exert even force upwards until the daughter card connector is removed from the
connector on RTM-ATCA-7350. As shown in step 2 of the figure below, remove the
daughter card by facing the daughter card at an angle of 45° to the RTM.
