Equipment Installation Manual,
GEN-X Electronic Flight Bag
1069-2510-01 D.doc
1069-2510-01
Rev D
Page 20 of 27
CONNECTOR PIN OUT:
The GEN-X RPU contains three male connectors,
J1 (Note: The mate for this connector is normally part of pre-made interface cable P/N 1069-4700-XX)
Pin Signal Function
A Power Common Power Common
B Aircraft Common Chassis Ground
C DA 0 (-) LVDS Data 0 (-)
D DA 0 (+) LVDS Data 0 (+)
E DA 1 (-) LVDS Data 1 (-)
F DA 1 (+) LVDS Data 1 (+)
G DA2 (-) LVDS Data 2 (-)
H DA2(+) LVDS Data 2 (+)
J CLK - LVDS CLK (-)
K CLK + LVDS CLK (+)
L LED 3 Emergency Operation warning light
M USB D0(-) USB Data 0 (-)
N USB D0(+) USB Data 0 (+)
P COM 2 TX RS232 COM 2 TX ( Touch Screen)
R COM 2 RX RS232 COM 2 RX ( Touch Screen)
S VMC 10 V + VMC10 in system Pwr +
T VMC 10 V- VMC10 in system Pwr -
U Power Ground Power Ground
V Power Ground Power Ground
J2 Standard Inputs
Pin Signal Function
A USB A+ USB 1 Power
B Ethernet Ground Ethernet Shield
C A+ (Ess) 28 VDC Power from Essential Buss
D A- (Emer) Power Common (Emer)
E A+ ( Emer) 28 VDC Emergency Buss Monitor
F Com 2 Common RS-232 Bus Common
G Com 1 TX RS 232 TX
H Com 1 RX RS 232 RX
J ET 6 Ethernet wire 6 (Rx-)
K ET3 Ethernet wire 3 (Rx+)
L ET1 Ethernet wire 1 (Tx+)
