Prestige 2000W Quick Start Guide
21
Procedure to View a Product’s Certification(s)
1 Go to www.zyxel.com.
2 Select your product from the drop-down list box on the ZyXEL home page to go to that product's page.
3 Select the certification you wish to view from this page.
The signal icon
() is blinking
The signal quality is low or the Prestige cannot find the AP.
Connect to another AP.
Move your Prestige closer to the AP.
There may be too much radio interference (for example a microwave or another AP using the
same channel) around your wireless network. Relocate or reduce the radio interference.
“Net Fail!
(DHCP)”
displays.
The Prestige failed to obtain an IP address from a DHCP server.
Make sure your wireless LAN settings are correct.
Make sure the DHCP server is operating properly.
Restart the Prestige.
“Net Fail!
(PPPoE)”
displays.
The Prestige failed to obtain an IP address from the ISP.
Make sure your PPPoE settings are correct.
Restart the Prestige.
“Not Registered”
displays
The Prestige failed to register with the SIP proxy server.
It is still possible to place a direct IP to IP call without the SIP proxy server. You must create
and use a phonebook entry (see Section 4 on page 17).
Check your SIP settings.
Contact your voice service provider.
PROBLEM CORRECTIVE ACTION
VoIPon Solutions www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0) 1245 600560