Filter
Top Products
7
Getting Started
Before You Install
1. Choose a location for the Base near an electrical outlet and a telephone
jack. This phone requires a modular telephone jack and a standard electri-
cal outlet (110V AC) not controlled by a wall switch.
2. Install the Handset battery. Use only VTech batteries.
Installation
a) Remove battery
compartment cover
by pressing on the
indentation and slid-
ing downward.
b) Align the two holes in the plug with the
socket pins, then snap the plug into place.
c) Place the battery in the compartment with
the wires in the lower right corner. Angle
the top of the battery under the top claws
first, then snap the bottom of the battery
in. Place the wires under the guide, located
below the battery.
d) Replace battery compartment cover.
3. Plug the DC connectors to the Base. Plug the AC adaptors into an electrical
outlet. Connect the telephone line cord to the jack on the Base, and the other
end to a modular telephone jack, as illustrated on the next page.
4. Place the Handset in the Base. Charge the battery for 10-12 hours.