Filter
Top Products
14
Basic Operation
1: 1
2: A B C 2
3: D E F 3
4: G H I 4
5: J K L 5
6: M N O 6
7: P Q R S 7
8: T U V 8
9: W X Y Z 9
0: 0
* *
#: & ’ , - . #
You can store up to 9 telephone numbers with names (up to 15 characters, 24 digits
each location) you dial frequently into the Speed dial memory locations you assign (1
though 9) in the Handset.
You can also store telephone numbers with names alphabetically in the directory. See
Telephone Directory for instructions.
NOTES:
1. The entries you store in Speed dial memory will be marked with 01 through
09 and also display in the directory.
2. Press OFF at any time to exit speed dial mode.
Store a Number/Name in Memory
1. Press PROG. Then press or until the screen displays SPEED DIAL.
2. Press SEL. The screen displays ENTER 1-9.
NOTE: When memory is full, the screen displays MEMORY FULL, an error tone
sounds, and you will not be able to store a new record until you delete a
stored record the speed dial memory or telephone directory.
3. Press the key (1 through 9) to assign the memory location for your entry. The
screen displays ENTER NAME.
NOTE: If the location is not empty, your new entry will be stored in place of the old
and will delete the former entry. Take caution to not save over entries you do not
wish to delete from memory.
4. Using the chart below, enter up to 15 characters for the name you’re storing.
Use
to backspace and make corrections; use to add a space.
Speed Dial
5. When you finish entering the name, press SEL or PROG. The screen dis-
plays ENTER NUMBER.
6. Enter the telephone number. Use to backspace and make corrections.
Press REDIAL/PAUSE to enter a pause if necessary.
Presses
Dial Key 1 2 3 4 5 6