Filter
Top Products
26
Dialing From Memory
• Press PHONE to get a line.
• Press MEM , you're prompted to
enter a speed dial location number:
NOTE:
The ability to temporarily add memory
contents to digits already entered on
the display operates in the same way
for CID and speed dial memories.
In this way, long distance and area
codes (for example, 1503) can be
entered on the LCD and can preface
numbers recalled from CID memory
before dialing. This is important
because only the last 7 digits of any
number are displayed when dialing
from CID memory.
Changing Stored Numbers
To change or replace a stored number
simply enter the new number on the
display and store it in the memory
location you wish to change.
Deleting Stored Numbers
• Press MEM . The display will
change to "SPEED DIAL
LOCATION_ _".
• Enter memory location number
(01-20).
• Press CLEAR/DEL key. The display
will change to "LOCATION XX
DELETED".
• Press OFF to exit.
NOTE:
Stored numbers are retained in memory
even if the base loses its power or the
handset battery is removed.
MEMORY DIALING
• Enter a 2 digit location number
(01-20)
• The number stored in that location
will be displayed and immediately
dialed.
Or
• Beginning from the OFF mode,
press MEM followed by a 2 digit
location number (01-20).
• Press MEM again to exit memory
dial mode and leave the number on
the display.
• Note that if digits were on the
display prior to entering memory
dial mode, the contents of the
speed dial memory will be ap-
pended to those digits. For exam-
ple, if 1503 was on the LCD and
the contents of the memory location
is 6438981, then the display would
show the following upon exiting
memory dial mode:
Press PHONE , the number on the
display will be dialed after a 2
second pause.
1920manual 1/28/99, 3:28 PM26