Filter
Top Products
13
GETTING STARTED
Charge the handset battery pack
before use. The battery pack recharges
automatically whenever the handset is
in the base unit. The batteries must
be charged for 16 hours before using
your phone for the first time.
Setting Up Your VTech VT 1920c
Choose an area near an electrical
outlet and a telephone wall jack.
AC Power Adaptor
Plug the AC power adaptor into an
electrical outlet and the DC connector
to the back of the base unit.
CAUTION:
Use only CLASS 2 9V DC POWER
SUPPLY included with your phone.
Handset Ringer
The handset ringer is programmed ON
as the factory default setting. Refer to
PROGRAMMING THE RINGER on
page 21 for more information.
Setting the Tone/Pulse Switch
The TONE/PULSE switch is located on
the bottom of the base unit and is
factory set to TONE. If you have touch
tone service, do not change the switch
setting. If you have rotary (Pulse)
service, set the switch to PULSE.
TELEPHONE
WALL JACK
AC
OUTLET
9V DC
TEL LINE
TONE
TONE PULSE
SELECTION
PULSE
Connect Telephone Line Cord
Plug one end of the telephone cord into
a wall jack and the other end into the
back of the Base Unit.
POWER
HS IN-USE
CHARGING
SPARE BATT
DIGIT
CORDL
CHARGE THE
HANDSET
BATTERY PACK
FOR 16 HOURS
BEFORE USING
1920manual 1/28/99, 3:27 PM13