Filter
Top Products
Follow the steps below:
1.
Remove the battery case cover by
pressing on the ridged lines and
slidina downward.
PRESS
and
SLIDE
DOWNWARD
2.
Discard the old battery pack. Don't
put the old battery pack in a trash
compactor or a fire
-
it could burst.
3. Place the new battery pack in its
housing with the metal contacts
facing down.
-
PLACETHE
NEW
BATTERY
PACK
INTOTHE
EATERY
COMPARTMENT
PLEASE NOTETHE
CORRECT POSITION
OF THE EATERY
PACK WHEN
CHANGING
BAlTERY
4.
Replace the battery case cover by
sliding the cover upwards.
SLIDE
IN
THE
BAlTERY
COVER
5.
If the new battery pack is not SElTlNG UP YOUR VTECH
VT1900
already charged, place the handset
1.
Choose an area near an electrical
in the cradle of the base unit to
outlet and a telephone wall jack.
allow it to charge for
8
hours.
2.
Connect your telephone Line Cord.
To Reduce the Risk of Fire or Injury
AC POWER ADAPTER
to Persons, Read and Follow the
Plug the AC power adapter into an
Instructions
electrical outlet and the DC connector
to the back of the base unit.
1.
Use only VTECH rechargeable
battery pack.
2.
Do not dispose of the battery in
a
fire. The cell may explode.
IMPORTANT:
Do not dispose of this battery into
household garbage. For informa-
tion on recycling or proper disposal,
consult your local solid waste
col-
lection or disposal organization.
3. Do not open or mutilate the battery.
Released electrolyte is corrosive
and may cause damage to the
eyes or skin. It may be toxic if
swallowed.
4.
Exercise care in handling batteries
in order not to short the battery with
conducting materials such as rings,
bracelets, and keys. The battery or
conductor may overheat and cause
burns.
To purchase replacement battery
packs, call VTECH Communications at
1-800-624-5688,
In Canada, call
WECH Electronics at
1-800-267-
7377.
TELEPHONE
WALL
JACK
t
4
HANDSET RINGER
The handset ringer is programmed
ON
as the factory default setting. Refer to
PROGRAMMING THE RINGER on
page
19
for more information.
SElTlNG THETONUPULSE SWITCH
TheTONUPULSEswitch is located on
the bottom of the base unit and is
factory set to TONE. If you have touch
tone service, do not change the switch
setting. If you have rotary (Pulse)
service, set the switch to PULSE.
CHARGE THE HANDSET BAlTERY
PACK BEFORE USE
The battery pack recharges
automatically whenever the handset is
in the base unit. The batteries must
be charged for
24
hours before using
I
I
your phone for the first time.
FOR
THE
FIRST
TIME.
TONE
SELECTION
PULSE
3
w
d
-.n
e
0
0