VTech VT 1900 Cordless Telephone User Manual


 
This equipment complies with Parts
15
BASE UNIT CONTROLS AND FUNCTIONS
and 68ofthe ~ederal Communications
Commission (FCC) rules for the United
-
TONEIPULSE
AC POWER JACK
PHONE CORD JACK
ANTENNA
BAlTERY
CHARGE
INDICATOR
IN
USE
INDICATOR
HANDSET
CHARGE
INDICATOR
POWER
INDICATOR
MEMORY
DIALING
CARD
PAGE
KEY
BATTERY COMPARTMENT
MODEL
Wl9W
rn
CHARGING
CONTACTS
MAIN FEATURES
ON
BASE UNlT
5
States. lt alsocomplies with regulations
RSS210 and CS-03 of Industry and
Science Canada. Operation is subject
to the following two conditions:
(1) this
device may not cause interference,
and (2) this device must accept any
interference, including interferencethat
may cause undesired operation of the
device.
A
label is located on the underside of
the base unit containing eitherthe FCC
registration number and Ringer
Equivalence Number (REN) or the IC
registration number and Load Number.
You must, upon request, provide this
information to your local telephone
company.
This equipment is compatible with
inductively coupled hearing aids.
Should you experience trouble with
this telephone equipment, please
contact:
VTECH COMMUNICATIONS
SERVICE DEPT. at 1-800-624-5688.
In Canada, call VTECH Electronics at
1-800-267-7377.
For repairlwarranty information. The
telephone company may ask you to
disconnect this equipmentfrom the line
network until the problem has been
corrected.
FCC
Part
15
Warning: Changes or modifications to
this unit not expressly approved by the
party responsible for compliances could
void the user's authority to operate the
equipment.
The equipment has been tested and
found to comply with part
15
of the FCC
rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation. If
this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try and correct
the interference by one or more of the
following measures:
Reorient or relocate the receiving
antenna.
Increase the separation between
the equipment and receiver.
Connect the equipment into an
outlet or on a circuit different from
that to which the receiver is
connected.
Consult the dealer or an
experienced
radiorrV technician
for help.