www.vtechphones.com
34
Outgoing announcement
Your answering system is pre-programmed with an announcement for normal (answer and record)
mode. If the phone is set up to record messages, the phone answers calls with “Hello. Please leave
a message after the tone.” You can use this announcement, or replace it with a recording of your
own.
Record outgoing announcement
1. Press SETUP, the system announces “Announcement. Press PLAY or press
RECORD. To continue set up, press SETUP.”
2. Press
REC/MEMO. After you hear “Record after the tone. Press STOP when you
are done,” speak toward the MIC to record an announcement for up to 90
seconds.
3. The elapsed time (in seconds) is shown in the message window when
recording.
Answering system operation
• Caller ID provides
the time and date.
Set the year so
that the day of the
week can be set
from the caller
ID information.
After setting the
time once, it will
thereafter be set
automatically with
incoming caller
ID information.
The time will be
set automatically
only if the caller
ID service is
subscribed
from your local
telephone
company.
•
Announcements
less than three
seconds will not
be recorded.
Menu features
System announces Description
“Announcements” Change the code, (set to 19 at the factory,) required to listen to
messages from a remote touch-tone phone.
“Remote access code” Set code to access remotely from a touch tone phone.
“Message alert” Beeps every 10 seconds when there are new messages.
“Announcement only” Outgoing message only. No recording of incoming messages.
“Call screening” Turn call screening on or off.
“Number of rings” Change the number of times the system rings before it answers a call,
(2, 4, 6 or toll saver).