Filter
Top Products
Appendix
71
Add and register a headset
The telephone system accommodates up to two cordless headsets. You can
add a new headset (IS6100, purchased separately) to your telephone system.
The headset must be registered with the telephone base before use. You may
need to charge the headset before registering it to the telephone base. For more
details on headset charging, see page 5.
To register a headset:
Place the non-registered headset in the
telephone base and allow it to charge
for at least 15 minutes before beginning
registration. Remove the headset from
the telephone base. The light on the
headset flashes slowly and alternately in
red and blue.
On the telephone base, press and hold
/FIND HANDSET for about four seconds
until the red IN USE light turns on.
Immediately place the headset in the telephone base. It takes about 60
seconds to complete the registration. The red IN USE light on the telephone
base turns off. The light on the headset turns red when it is registered but
not fully charged, or turns blue if it is registered and fully charged.
If registration is successful, you hear a dial tone when you press on the
headset. If registration fails, you hear “Not registered” through the headset
earpiece when you press on the headset. The light on the headset flashes
slowly and alternately in red and blue. To reset the headset, remove it from
the telephone base and then place it back into its charger. Try the registration
process again.
The headset must be deregistered before registering it to another telephone system.
1.
2.
3.
The light