Filter
Top Products
32
Headset Operation
Your 20-2432 Handset is equipped with a 2.5mm Headset Jack for use with
an optional accessory Headset for hands-free operation. If you choose to use
the Headset option, you must obtain an optional accessory Headset, which
is compatible with the 20-2432.
Once you have a compatible 2.5mm Headset, locate the Headset Jack on the
20-2432 Handset. Connect the plug on the Headset cord to the jack(under a
small rubber flag) on the cordless Handset. The plug should fit securely. Do
not force the connection.
Headset Operation connected to
the Handset
NOTE :
Whenever a compatible Headset is
connected to the cordless Handset, the
microphone on the Handset will be
muted. This is done to limit the effect
of background noise.
Headset Operation connected to
the Base Unit
The same type of Headset can be
connected to the Base Unit. Facing the
Base, the Headset jack can be found
on the near corner of the right side
panel.When using a Headset attached
to the Base, calls are made and
answered by pressing the HEADSET
key. This key is also used to end your
call. The Base Speakerphone and
Base Headset cannot be used
simultaneously. However, you can
switch between the two modes by
pressing SPEAKERPHONE and
HEADSET without disconnecting
your Headset.
Belt Clip
The 20-2432 is also equipped with a
detachable belt clip. Align the pins
on the inside edge of the clip with
the notches on the sides of the 20-
2432 Handset. The belt clip should
snap securely into place. Do not force
the connection.
Additional Information