Filter
Top Products
3 947101
NOTE: The intercom used MUST supply a holding
ground or page control lead to properly operate the
V-1101A. A page control lead is a lead that supplies
Ground whenever the intercom is in use, and which is
Open when the intercom is idle. Contact the
manufacturer of your intercom if you have questions
about this lead.
Operation: Press the intercom button and dial the
number assigned to the V-1101A. You will then be
connected to the paging speakers. Make
announcement. The V-1101A will automatically
disconnect when you hang up.
Page Port Access
CAUTION: To use the V-1101A on a PABX or
electronic key system page port, the telephone system
MUST SUPPLY both an audio pair AND a dry
contact closure.
When accessing the V-1101A from a page port, the
following equipment will be required:
• (1) V-1101A One Zone One-way Page Adapter
• Telephone system page card (if page outputs are
not built in)
• Valcom one-way amplified speaker assemblies
(quantity and style determined by specific
installation)
• A –24 Vdc power supply (size and quantity
determined by number and style of speakers)
Operation: Follow the telephone system
manufacturer's instructions for accessing paging.
Make announcement. The V-1101A will
automatically disconnect when you hang up.
Background Music
Background music may be connected to the V-1101A
when using any of the above configurations. The
background music will automatically cut off when the
paging is accessed.
The background music source should have a output
impedance of approximately 8 Ohms. An output
level of 1 watt will be more than sufficient to drive
the amplified speakers. The background music
source must have it's own volume control.
The wiring of each arrangement is covered in the next
section.
INSTALLATION
General
These instructions cover the installation procedures
for the Valcom V-1101A and any associated
equipment. Please consult practices for other
manufacturer's equipment if any other equipment is
being used. Refer to Figure 2 for connection block
pinouts.
The following sections contain step-by-step
instructions for wiring the Valcom V-1101A one zone
one-way page adapter. Each instruction is preceded
by a line. Place a check on the appropriate line as the
instruction is completed. The instructions also
include tests along the way to verify connections have
been made correctly. If these steps are followed
exactly, installation of your Valcom system will go
smoothly and quickly. If the results of a test do not
correspond with what is shown, DO NOT PROCEED
UNTIL THE PROBLEM HAS BEEN
CORRECTED.
__ NOTE: To facilitate system testing and
balancing, be sure to set the individual
volume controls at approximately 1/2
volume when installing one-way amplified
speaker assemblies.
Mounting
NOTE: DO NOT install the V-1101A or its wiring
closer than 18" to a power supply or any equipment
that generates electrical noise.
__ 1. If you are using the Valcom VM-101
mounting frame:
__ (a) Using two #6 3/4" wood screws, mount the
frame on a vacant space on the backboard
with the telephone system common
equipment.
__ (b) Using the bolts supplied, attach the
V-1101A to the mounting frame.
__ (c) Plug the amphenol ended cable into the
V-1101A.
__ (d) Attach the V-1101A terminal designation
strip to the punch down block on the frame.
__ 2. If you are using a separate punch down
block and cable:
__ (a) Using two #6 3/4" wood screws, mount the
unit in a vacant space on the backboard with
the telephone system common equipment.
__ (b) Mount a 66 type punch down block near the
unit.