Filter
Top Products
6
Copyright 2006 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
Getting Started
This section explains how to install and charge the battery, how to check battery
status, how to turn on the PA600, and how to calibrate the screen.
Installing the Battery
WARNING! There is a risk of fire and burns if the battery pack is handled improp-
erly. DO NOT disassemble, crush, puncture, short external contacts,
or dispose the battery pack in fire or water. DO NOT attempt to open
or service the battery pack. Dispose of used batteries according to
local recycling guidelines in your area.
A backup battery cell is embedded into your device to prevent data loss in instances
when the removable battery pack is removed or completely discharged. This backup
battery cell will only support the system for a maximum of 60 minutes.
NOTE: To enable the internal battery cell to provide backup power supply,
charge your device with the main battery pack for at least 12 hours.
1. Open the battery compartment by pushing the latch in the direction of the arrow
and lifting up.
The battery compartment is displayed:
NOTE: The plastic battery tab makes it easy to remove the battery.
Compartment contacts
Plastic battery tab
Battery securing clip